Reaktor 4
-
JonathanDragonDJ JonathanDragonDJ https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=54723
- KVRian
- Topic Starter
- 510 posts since 13 Jan, 2005
how do you batch save in reaktor 4?
i need to convert over all my old R3 libarary
i need to convert over all my old R3 libarary
-
- Banned
- 6127 posts since 1 Apr, 2004 from Et in Arcadia Ego
File-> Batch processing. Set your target & destination folder & that's it.
- KVRAF
- 9216 posts since 23 Jul, 2002 from Pequot Lakes, MN
1) Have your R3 dongle installed and plugged in.
2) Move all the ensembles, etc. you wish to convert to the same folder (or convert for each subfolder).
3) Go File/Batch processing. The dialog will give you the options of source and destination folders.
4) Click on start. There isn't an automatic close at the end or anything, so after the conversion's done, hit cancel to close the window.
You need R4.11 and up for this to work.
Ah...good morning, Don
ew
2) Move all the ensembles, etc. you wish to convert to the same folder (or convert for each subfolder).
3) Go File/Batch processing. The dialog will give you the options of source and destination folders.
4) Click on start. There isn't an automatic close at the end or anything, so after the conversion's done, hit cancel to close the window.
You need R4.11 and up for this to work.
Ah...good morning, Don
ew
A spectral heretic...
-
- Banned
- 6127 posts since 1 Apr, 2004 from Et in Arcadia Ego
Hola!ew wrote: Ah...good morning, Don
ew