KVR Audio

Chris-S · Post by **Chris-S** » Tue May 17, 2016 12:52 pm

This should be an easy subtractive sound but I was not yet able to get close.

https://youtu.be/bsDhHPuixuk
at 1:16 - 1:29 and 2:23+

Chris

brainzistor · Post by **brainzistor** » Wed May 18, 2016 3:13 pm

Brassy sound is achieved when you detune one (first one) oscillator and lower the attack (ADSR), first one should be saw, second one too, but you can experiment with second one. Then lowpass in filter and lower the attack in filter. Oscillators should be synced. IMO, the most crucial thing is to lower the attack in filter and ADSR, that's when you start getting the brassy sound. Take Synth1 and try it, the first patch is already a brassy pad, just move a few knobs here and there and you'll get that clean brassy lead sound. See what's going on and apply it on whatever synth you want, Sylenth1, whatever...

lalo · Post by **lalo** » Wed May 18, 2016 4:06 pm

And i a little modulation on second oscillator via a fast decay envelope could help too. I just did a quick Diva patch as an exercise.

Chris-S · Post by **Chris-S** » Wed May 18, 2016 5:59 pm

Thanks, also I think unison is used in this sound.

Vintage Lead (1982)