Changing the decay value is not possible when in Collisions tab (greyed value box), even though different values have different effect. It is possible to change the value by switching to the spectrum tab and then back again which is quirky.
Either the decay value should be meant to be set to a default value in Collision analyzer or the greying out is a mistake, imho.
Quirk in MMultiAnalyzer
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122
- KVRAF
- 14019 posts since 15 Mar, 2008 from Czech republic
Hmmm, good point, I'll check it out!