KVR Audio

pianogutten · Post by **pianogutten** » Sun Mar 13, 2005 7:15 pm

hi! I have bought a behringer bcr2000 midi controller. I have one problem.. when I set knob called "type" control change and the "CH" knob to control change - the "type" knob stops working when I use the "CH" knob. If i use another knob then the "Type" starts working again.. this is very frustrating!

please help!

C00kie · Post by **C00kie** » Tue Mar 15, 2005 7:47 am

Read the manual... is this supposed to happen maybe?

pianogutten · Post by **pianogutten** » Tue Mar 15, 2005 8:21 am

tryed, but can't understand this.. maby my bcr2000 is damaged.. think it's strange with a totaly new one...

M'Snah · Post by **M'Snah** » Sat Mar 19, 2005 4:54 pm

AFAIK the TYPE and CH labels have nothing to do with the normal operation of these knobs. They're only used for configuration of the knobs.

Does this happen all the time? or only in special cases? Did you reconfigure the knobs? or connect to specific controls on screen?

--HansM

Jupiter Prime · Post by **Jupiter Prime** » Sun Mar 20, 2005 1:17 am

I've tested it, and it works fine here.
here's what i did,

(btw. I was in 'user mode-1' , but it should make no difference)

- push & hold [edit], then move knob 1 (= encoder 1, the one labled 'type').

**the display will now show 'E1'.**

- release [edit]
- turn encoder 1 again to set its type (u can now cycle thru the 'types'; cc, nprn, etc.).
- turn encoder 2 to set the midi tx/rx channel. (1-16)
- turn encoder 3 to set the CC controller number (0-127).
- turn encoder 4 to set the Min. value (0-127)*.
- turn encoder 5 to set the Max. value (0-127)*.
- turn encoder 6 to set the Controller mode**.
- turn encoder 7 to set the Controller option**.
- turn encoder 8 to set the Display value indication (On/Off).

then i repeated this for encoder 2 (the one labled 'CH').

Jupiter Prime · Post by **Jupiter Prime** » Sun Mar 20, 2005 1:25 am

whoops...

* if u set both values the same, the knob wont work. (e.g.
min = 127, max = 127, theres no value inbetween).
** see manual for details on mode & option

p.s.
don't forget to STORE the preset

David Boura · Post by **David Boura** » Fri Sep 30, 2016 4:23 pm

@Jupiter Prime : are you the author of your signature? I've found this quote apparently from an unknown elsewhere on the web?

BertKoor · Post by **BertKoor** » Sat Oct 01, 2016 4:59 pm

@david: JupiterPrime has last posted here in 2005 which is 11 years ago. I doubt you'll ever get an answer.

bcr2000 problem knobs stops workin