How to feed a Comb1 ?
-
- KVRist
- Topic Starter
- 58 posts since 29 Sep, 2012
hello,
is it possible to feed Comb1 with a signal form another module? (zebra2)
Eg. osc1-------> Comb1---->output(Master)
1. I mean ocs1 makes a sound/wave/etc...
2. that sound/wave is used in comb1 as input.
But i dont want to hear original sound from osc1.
There is a Input and a Dry knob in Comb1 but i dont get it.
best regards
is it possible to feed Comb1 with a signal form another module? (zebra2)
Eg. osc1-------> Comb1---->output(Master)
1. I mean ocs1 makes a sound/wave/etc...
2. that sound/wave is used in comb1 as input.
But i dont want to hear original sound from osc1.
There is a Input and a Dry knob in Comb1 but i dont get it.
best regards
- KVRAF
- 23102 posts since 7 Jan, 2009 from Croatia
Just put a module before Comb and that counts as input.
- KVRAF
- 4123 posts since 23 May, 2004 from Bad Vilbel, Germany
It's all very clear in the manual, pinso. Pages 38 to 40.
And what EvilDragon wrote actually answered your question. Thanks, Evil One
And what EvilDragon wrote actually answered your question. Thanks, Evil One
-
- KVRist
- Topic Starter
- 58 posts since 29 Sep, 2012
Well, tbh it doesn't helped so much.
Obviously there should be a module before comb1 (like i sketched it above), when i want that signal. (Not the internal comb1 signal)
The problem was more in the PreFill-knob and Dry-knob.
Maybe i didn't express myself better.
But no offense to him or everyone. He gave me some good answers in the past.
I am always thankful for answers.
Btw, the information i found, is actually from the manual.
Obviously there should be a module before comb1 (like i sketched it above), when i want that signal. (Not the internal comb1 signal)
The problem was more in the PreFill-knob and Dry-knob.
Maybe i didn't express myself better.
But no offense to him or everyone. He gave me some good answers in the past.
I am always thankful for answers.
Btw, the information i found, is actually from the manual.