VST Time info and cycle
-
- KVRAF
- Topic Starter
- 3475 posts since 6 Oct, 2001 from europe-norway-oslo
Hi, anyone know any VSTi's that supports VST Time info with cycle?
I have setup a 4 bar loop in energyXT's sequencer, but I can't get any VSTi's to work when loop is active. I have tested with FL Studio and MicroTonic so far.
They both work nicely when cycle is disabled though...
cheers
jorgen
I have setup a 4 bar loop in energyXT's sequencer, but I can't get any VSTi's to work when loop is active. I have tested with FL Studio and MicroTonic so far.
They both work nicely when cycle is disabled though...
cheers
jorgen
-
- KVRist
- 43 posts since 11 Dec, 2003
The MicroTonic uses and needs the cycle information in the VST timing info to maintain correct sync.
The cycle positions are essential since the MicroTonic bases its synchronization on the current song position and tempo. If the host would loop without having reported its cycle positions, the MicroTonic could sort of get caught by surprise, since the host song position would suddenly change. This can cause funny effects like missing notes etc.
What problems are you having exactly with cycling enabled?
The cycle positions are essential since the MicroTonic bases its synchronization on the current song position and tempo. If the host would loop without having reported its cycle positions, the MicroTonic could sort of get caught by surprise, since the host song position would suddenly change. This can cause funny effects like missing notes etc.
What problems are you having exactly with cycling enabled?
-
- KVRAF
- Topic Starter
- 3475 posts since 6 Oct, 2001 from europe-norway-oslo
oops, my fault again, I was messing up the 'flags' member of the timeinfo recordWhat problems are you having exactly with cycling enabled?
It works perfectly in cycle now, with real-time tempo changes and all
thanks
jorgen