Does ChineePiPa support pitch bend?
-
- KVRer
- Topic Starter
- 2 posts since 16 Dec, 2012
I want to do some pitch bends with the pipa, but it doesn't seem to support it. Is it possible to do this (aside from the glide feature)? If so, please tell me how I can accomplish it. Thanks.
-
- KVRian
- 799 posts since 25 Feb, 2005
Hi berrisbob,
QIN RV works fine with standard MIDI pitchbend by default, and it should be very obvious once you start bending a note. What is your host? *If you are using Fruity, please check this thread (on the 2nd page) for some explanations:
http://www.kvraudio.com/forum/viewtopic.php?p=5033378
QIN RV works fine with standard MIDI pitchbend by default, and it should be very obvious once you start bending a note. What is your host? *If you are using Fruity, please check this thread (on the 2nd page) for some explanations:
http://www.kvraudio.com/forum/viewtopic.php?p=5033378
-
- KVRer
- Topic Starter
- 2 posts since 16 Dec, 2012
I was using Sonar X1. I was finally able to get it to work by explicitly selecting channel 1 for the envelope's controller (even though it was already channel 1 by default).
Thanks for the quick reply.
Thanks for the quick reply.
-
- KVRian
- 799 posts since 25 Feb, 2005
Hi berrisbob,
I can't reproduce the issue here in X1. Make sure you are using the new QIN RV Pipa if haven't done so yet...
I can't reproduce the issue here in X1. Make sure you are using the new QIN RV Pipa if haven't done so yet...