MUTOOLS

mgiambro · Post by **mgiambro** » Fri Oct 17, 2014 11:53 am

First off. I've only recently switched to MuLab and am really enjoying using this well thought out, efficient yet powerful DAW.

I think a nice addition would be to have a separate volume control on the browser. I often find that when I'm previewing samples, some are much louder than the mix levels I have in the track and I therefore have to use the volume on the audio interface to adjust.

Keep up the good work and I look forward to digging deeper into MuLab and MUX.

sbj · Post by **sbj** » Fri Oct 17, 2014 1:24 pm

If you go into Modular area there is an audio file previewer
(double click it) where you can adjust the volume.

mgiambro · Post by **mgiambro** » Fri Oct 17, 2014 1:48 pm

sbj wrote:If you go into Modular area there is an audio file previewer
(double click it) where you can adjust the volume.

Right. I was wondering if I had missed it. Looks like I did. I guess this request is redundant.

Thanks for the reply.

runaudio · Post by **runaudio** » Fri Oct 17, 2014 7:47 pm

check the modular u said all i see is audio input and output and master and metronome

runaudio · Post by **runaudio** » Fri Oct 17, 2014 8:50 pm

sorry my fault found it

MUTOOLS

KVR Audio

[SOLVED]: Separate volume control on the browser