Renaming patches in Soundbanks

[rsturge]

Just got version 3.024, can't figure out how to name a preset something other than Init.

Scenario:
Created a new bank (really just copied and renamed a factory bank)
Created a new patch in the new bank. (Init)
Saved the new patch as new preset. (myPatchName)
Load the patch to the new bank.
Click the "dot" to rename the preset from Init to myPatchName (must be a new copy in made of the preset in the new bank requiring a new name?)

New name cannot be saved. Any action taken after clicking the "dot" reverts the name back to Init. The preset is loaded into the bank, it is just the name that cannot be changed. And so every new patch is named Init

64bit sylenth
host is 64 bit Reaper

[Lennard]

You should change the name BEFORE saving the preset, not after. The correct order would be:

1. Click the dot on the left side of the preset name to edit the name.
2. Save preset via MENU -> Preset -> Save
3. Load the preset via MENU -> Preset -> Load

[rsturge]

Thanks for the response.

Trouble is, this doesn't work either:
a. Clear preset and create new patch from Init.
1. Click the dot on the left side of the preset name to edit the name.
2. Save preset via MENU -> Preset -> Save

or
1. Click the dot on the left side of the preset name to edit the name.
1a. Rename existing patch.
2. Save preset via MENU -> Preset -> Save

Once you leave the focus of that text box after inputting the name to head to the menu to save, it reverts to back to whatever the preset name was originally.

Its like there is a config setting somewhere that has got me in "can't save new patch" mode
(this is licensed version btw)

Also, in case it makes a difference , there is no MENU -> Preset -> Save,
just MENU -> Preset -> Save As

[vegaron]

I noticed that the name will not be changed if you leave the focus of the text edit field by clicking somewhere with the mouse. You have to use <Enter> to leave the edit field.

[rsturge]

That is it. Thank you.