I read the request of VeXKoN about two outputs and it's a good thing.
But in fact, which would interest me is an audio output for each section of the gate (what makes three outputs HI - MID - LO) to mix them independently in Live 6.0.7.
For example, in the "Lm4MarkII", with which one can recover the various outputs on various tracks, I also use there "SooperLooper" in the same way.
In fact, in Live, the outputs of these plugins are found listed in the control panels of the inputs and the outputs section of each tracks (exactly in the inputs section of each tracks)

Thanks again for this really huge software.

Kri

ACT
act@kirikino.net
http://www.kirikino.net
http://www.myspace.com/actkirikino

Oups, sorry Aldo I've just read enterely "The ultimate request for Stormgate vX" Topic and I see that my request is the same.
Sorry again.

Kri

ACT
act@kirikino.net
http://www.kirikino.net
http://www.myspace.com/actkirikino

No problem!
The 3+3 (gated + non-gated) output version is almost ready to be released!

Thank you very much Aldo !!

Kri

Wahoooooooooooo!!! Thanks Aldo!! This would be very, very useful indeed. I am staying in tonight so will be able to have my first play with the first full release of Stormgate. The thing is there are so many new and exciting plugins being released that it is hard to not remain focused on actually using what you have rather than downloading the latest plugins and updates!! Thanks for such a fantastic, innovative product and great customer service Aldo!!!

Thanks to you!

It's almost ready to be released. I think it needs a bit of testing before we can release it officially (but it should work 100%), so if you would like to try it please email me at aldo (AT) araldfx.com with your AraldFX user's name.
Specify if you want the MAC/VST or PC/VST version, and within some hours I'll be sending it by email. BTW, it's a relatively small file.

There are 6 stereo outputs.

The first 3 are for the low, medium and high band (Gated)
The other 3 are for the low, medium and high band (original minus gated signal)

Because it works just like the normal StormGate3, if you simply want to distribute the signal of each band over the 2 outputs, remember to set the Dry and Wet controls to the same level (CTRL+click should do the trick), and move the Dry/Wet control to full Wet.

If you just need a pure crossover... then there is one in the AraldFX ToolBox (be patient for a while). It can work in linear phase mode as well.

Have I get this right?

Separate outputs for each band consisting of:-

1 stereo "wet" signal - gated/distorted etc. for each band

+

1 stereo "dry" signal - ungated/undistorted signal for each band


This is even better than I expected - I wasn't expecting separate wet and dry outputs for each band aswell!! Fantastic!!

Email re. testing this version sent.

Thanks Aldo!!

Plug-ins sent... however this version of StormGate3 sends the signal that the gate removes to the additional outputs (the last 3.

So the gating envelope can be seen as a balance control between the primary and secondary output of each band.

If you wish to use StormGate3 as a regular cross-over, you should move the dry/wet control to full dry and use only the first 3 outputs. By stopping the sequencer you are also going to save some CPU as well.