I am using Albino 3.1.6 in Cubase 6.0.5 64-bit on Mac OSX 10.6.8. When I open the Cubase project on my Windows 7 64-bit, Albino uses the default preset. Not the one I am using.

Hi,

Do you mean with a old song or so?
Or also with current songs?

Rob

Hi.

With a current song.

Okay, but if you select the correct preset and then save the song. Is it then okay if you reload the song?

Yes - on Mac

On W7 the banks do not show up, shows ---

But the presets (some) show up and when I select a preset the banks appear.

Hi,

Run the installer again please.
You did not move files yourself? I mean inside the Albino3 folder. Did move them to another location after installing?

Rob

I'll do that.

No, I did not move any files or folders.

I started uninstalling the Albino.

Then I installed Albino (311) again on my W7 in 64-bit mode and said "yes" to everything - no user definitions.

I saved the project on Mac Cubase and the Albino master section says:

(Bank) Arpeggiator Sounds 1

(Preset) AttackSawCord2 arp

When I reopen it in Mac its ok.


When I open the Mac Cubase project on W7 Cubase the Albino master section says:

(Bank) ---

(Preset) Aioon

I selected the right bank and preset (the banks show up when I select a preset) and saved the project still on W7.

Then I reopen it on W7 and the Albino master section says:

(Bank) ---

(Preset) ---

On the mac the everything is ok opening the W7 saved project.

http://www.linplug.com/technical_support.html

Please contact LinPlug, that works best because this is not reported yet.

I will