|
|||
In spectral mode is it possible to load a sample and highlighting some spectrum areas à la isotope Iris? |
|||
| ^ | Joined: 07 Jan 2005 Member: #54120 | ||
|
|||
Yep. By multiplicate brush mode with lower ocapacity. |
|||
| ^ | Joined: 26 Jun 2008 Member: #183643 Location: Czech Republic | ||
|
|||
Check out this page of the manual:
http://www.camelaudio.com/alchemymanual/source/spectral-edit or/ The example towards the end is similar to the technique you are referring to. Part of a drum loop in copied using the spectral editor and pasted to a new position, altering the loop. With a bit of patience some really nice results can be achieved. Peace, Andy. |
|||
| ^ | Joined: 18 Jun 2008 Member: #183136 Location: Melbourne, Australia | ||
|
|||
ZenPunkHippy wrote: Check out this page of the manual:
http://www.camelaudio.com/alchemymanual/source/spectral-edit or/ The example towards the end is similar to the technique you are referring to. Part of a drum loop in copied using the spectral editor and pasted to a new position, altering the loop. With a bit of patience some really nice results can be achieved. Peace, Andy. Thanks for your replies! Anyway I believe Iris way is much straightforward and I Would be glad to see it in Alchemy. |
|||
| ^ | Joined: 07 Jan 2005 Member: #54120 |
| KVR Forum Index » Camel Audio | All times are GMT - 8 Hours |
|
Printable version |
Disclaimer: All communications made available as part of this forum and any opinions, advice, statements, views or other information expressed in this forum are solely provided by, and the responsibility of, the person posting such communication and not of kvraudio.com (unless kvraudio.com is specifically identified as the author of the communication).
Powered by phpBB © phpBB Group
