Im trying to sync my netbook and DAW as per this thread:
http://www.kvraudio.com/forum/viewtopic.php?p=5157206
To overcome the latency issue on the netbook (slave), I intend to create a delay on the DAW.
Therefore i need to know if it is possible to assign a delay to all events in a project except for MIDI Time Code?
That way by the time the MTC is received by the netbook, the audio/MIDI on the DAW will begin [/b]
Cubase Negative(?!) Delay Compensation
-
- KVRAF
- Topic Starter
- 15135 posts since 7 Sep, 2008
"I was wondering if you'd like to try Magic Mushrooms"
"Oooh I dont know. Sounds a bit scary"
"It's not scary. You just lose a sense of who you are and all that sh!t"
"Oooh I dont know. Sounds a bit scary"
"It's not scary. You just lose a sense of who you are and all that sh!t"
- KVRAF
- 6095 posts since 5 Jul, 2001 from Just about .... there
Each track in Cubase can be offset right on the channel editor.
Globally, I can't remember. If you can, it is on the page where you select which audio card you are going to use and which ASIO driver. I'm not near my DAW so can't look... sorry.
So, if you know the offset, you could set an audio track and duplicate that track as needed.
Globally, I can't remember. If you can, it is on the page where you select which audio card you are going to use and which ASIO driver. I'm not near my DAW so can't look... sorry.
So, if you know the offset, you could set an audio track and duplicate that track as needed.
If you have to ask, you can't afford the answer