KVR Audio

morelia · Post by **morelia** » Thu Oct 02, 2014 4:24 am

Is anyone else having issues with Melodyne in Reaper. Both programs are fully up to date versions. I have transferred files into Melodyne 3 times now and when I open the project again the files are missing. I tried setting different directories and I can see the file sitting there but it is greyed out in the Melodyne UI.

morelia · Post by **morelia** » Wed Oct 08, 2014 10:38 am

Anyone?

spaceman · Post by **spaceman** » Fri Oct 10, 2014 8:02 am

"Reaper, and the missing Melodyne files"

Isn't that a Tin Tin book?

morelia · Post by **morelia** » Fri Oct 10, 2014 9:23 am

I hope this story has a happy ending as well.

Shangsean · Post by **Shangsean** » Fri Oct 10, 2014 1:40 pm

I'm not sure about your exact problem, but I also had a lot of problems with Melodyne in Reaper and when I searched online, I found that Melodyne and Reaper don't seem to get along. I ended up just doing my Melodyne stuff in the stand alone version after rendering to audio. It's a pain, but it was better than having it crash all the time, which was my problem.

morelia · Post by **morelia** » Sun Oct 12, 2014 12:40 am

That's a good idea. Better than the current one of editing in one go and rendering the audio file. It seems like a very off issue and unfortunately Reaper is not supported by Celemony. This issue seems to have only started recently. Previously I had no issues other than a few minor GUI related oddities.