SOLVED : Wave Matrix to Key mapper bug ?
-
Burzukh_Studios Burzukh_Studios https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=263361
- KVRian
- Topic Starter
- 644 posts since 24 Aug, 2011 from Melbourne , Australia
Apparently, if I drag and drop wave matrices to key mapper with just fixed key toggle button on , it works fine, but if by chance the velocity layer toggle button is on (which normally is off for such cases),it halts.
Can someone replicate or confirm? 64 bit TX16WX in 64 bit Reaper in Win 8.
Can someone replicate or confirm? 64 bit TX16WX in 64 bit Reaper in Win 8.
Last edited by Burzukh_Studios on Mon Dec 08, 2014 9:26 am, edited 1 time in total.
-
Burzukh_Studios Burzukh_Studios https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=263361
- KVRian
- Topic Starter
- 644 posts since 24 Aug, 2011 from Melbourne , Australia
Another possible but in the wave matrices section : Though I can select multiple wave matrices to load, when I load, it only loads the first of my selection. This is not a big issue if you are working with a few wave matrices, but when you have over 40 it gets very cumbersome to load them one by one.
-
Burzukh_Studios Burzukh_Studios https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=263361
- KVRian
- Topic Starter
- 644 posts since 24 Aug, 2011 from Melbourne , Australia
Any news with the above two ?
Help would be appreciated...
Help would be appreciated...
-
- KVRAF
- 2400 posts since 27 May, 2005 from Stockholm
-
- KVRAF
- 2400 posts since 27 May, 2005 from Stockholm
-
Burzukh_Studios Burzukh_Studios https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=263361
- KVRian
- Topic Starter
- 644 posts since 24 Aug, 2011 from Melbourne , Australia