KV331 Audio

nineofkings · Post by **nineofkings** » Wed Mar 25, 2015 6:36 pm

I've been using Synthmaster a lot lately. However, the factory waveforms suddenly do not load, and simply load a sine wave instead. These include the AM, Asymmetrical, Iterations etc. through the UHF waves. The default saw, square etc. waveforms, and the "User" waveforms, such as the ones sampled from hardware synths, all load fine. It's just the waveforms stored in the "FactoryWaveforms" folder that do not load.

How can I fix this?

Adam_V · Post by **Adam_V** » Wed Mar 25, 2015 8:07 pm

It's a pretty common problem, and luckily it's an easy fix.

Go to "My Documents" (I assume you're on windows) and delete the "Synthmaster Temp" folder. When you relaunch Synthmaster the folder will be recreated and your waveforms should show up again. I hope that helps.

nineofkings · Post by **nineofkings** » Thu Mar 26, 2015 10:56 pm

That did the trick, thanks!

kv331 · Post by **kv331** » Mon May 25, 2015 11:55 pm

Not My Documents guys, Public (or Common) Documents/SynthMasterTemp folder.

I will try to fix this issue asap, but I couldnt figure out yet why it's happening. Clearing out the waveform cache is the temp solution for now!

Bulent

wagtunes · Post by **wagtunes** » Mon Jun 22, 2015 3:21 pm

Just happened to me as well. Cleaning out cache did the trick but as you said, temp solution. Hopefully, you'll determine the cause.

kv331 · Post by **kv331** » Wed Jul 01, 2015 10:06 am

Yes I am trying to figure out the test case for this.

KV331 Audio

KVR Audio

Factory waveforms suddenly not loading