Hi! So here I go:
1. (Minor) If you switch between osc 1 and osc 2 in Layer 1, then "Hi Cut" label is jumping. It needs to be repositioned. It's not the case with lyaer 2. Also the frame for the osc 2 is lighter than in osc 1.
2. ----
3. Filter Boost doesn't work? Or i don't know how to set up it?
Thank you!
Some bugs and strange behaviours in 2.7.4
-
- KVRAF
- 6578 posts since 14 Nov, 2006 from Ankara, Turkey
Regarding filter boost:
Basicly what it does is, it compensates for the gain reduction caused by increased resonance. you know, especially in analog filters gain is reduced when you increase resonance so boost will keep the gain constant.
Basicly what it does is, it compensates for the gain reduction caused by increased resonance. you know, especially in analog filters gain is reduced when you increase resonance so boost will keep the gain constant.
Works at KV331 Audio
SynthMaster voted #1 in MusicRadar's "Best Synth of 2019" poll
SynthMaster One voted #4 in MusicRadar's "Best Synth of 2019" poll
SynthMaster voted #1 in MusicRadar's "Best Synth of 2019" poll
SynthMaster One voted #4 in MusicRadar's "Best Synth of 2019" poll
-
- KVRAF
- Topic Starter
- 4968 posts since 26 Apr, 2007 from Noosphere
Great! Thank you. It's something some modern VA synths are missing (Hi Dune 2)kv331 wrote:Regarding filter boost:
Basicly what it does is, it compensates for the gain reduction caused by increased resonance. you know, especially in analog filters gain is reduced when you increase resonance so boost will keep the gain constant.
