I am a Logic Pro x user of sylenth and have seen the following and wondered if it is possible in my DAW also. I am not sure if this is sylenth routing or the setup within the DAW.
I saw a fl studio user have a layered synth using multiple instances of sylenth which were sent to an automation channel in which he adjusted the cut of of ALL instances at once.
Is this to do with sylenth routing/options or the DAW because I cannot figure out how to automate cut off en mass in Logic Pro x.
Group automation
-
- KVRer
- Topic Starter
- 6 posts since 4 Jan, 2016
-
- KVRer
- Topic Starter
- 6 posts since 4 Jan, 2016
PROBLEM SOLVED:
Turns out you can remap the smart controls and with multiple parameters/variables on a single knob. I did this via the track stack header.
I managed to map all he cut off's in the stack (doesn't even have to be the same AU, you could use any device/parameter). Also assigned the open and close points of the cutoff, all on a single knob.
I then drew in the automation for everything in the stack header!
Bingo!
This video was helpful if you are confused with some of the options like i was, i had no idea it was something so easy and simple...
https://www.youtube.com/watch?v=fXI_v1EULSA
Turns out you can remap the smart controls and with multiple parameters/variables on a single knob. I did this via the track stack header.
I managed to map all he cut off's in the stack (doesn't even have to be the same AU, you could use any device/parameter). Also assigned the open and close points of the cutoff, all on a single knob.
I then drew in the automation for everything in the stack header!
Bingo!
This video was helpful if you are confused with some of the options like i was, i had no idea it was something so easy and simple...
https://www.youtube.com/watch?v=fXI_v1EULSA
