KVR Audio

ATS · Post by **ATS** » Tue May 03, 2016 10:10 am

I cannot figure out how to just drag and drop a pattern into my sequencer. I am not even sure this is possible?

Pi-e · Post by **Pi-e** » Tue May 03, 2016 2:12 pm

yes, it is possible
I cant remember right now but there should be an icon on the right down corner just next to the pattern name..just click it and drag it

Pi-e · Post by **Pi-e** » Tue May 03, 2016 2:13 pm

...or maybe the pattern name itself

dblock · Post by **dblock** » Tue May 03, 2016 2:26 pm

ATS wrote:I cannot figure out how to just drag and drop a pattern into my sequencer. I am not even sure this is possible?

Hey ATS. Botton right hand side right above the BPM transport buttons you have to place the pointer on the word "Pattern" while holding the ALT button and drag it down. Hope this helps.

anyone here use MOTU BPM? (question)