As it is, you can't have a two bar bass riff in the pattern generator.
You can make a two bar bass preset but if a note crosses the chord change, it will be cut off. And as the chords can't be longer than one bar, the patterns in the examples will not work.
Solution: Increase maximum chord length to two bars (preferred) or add an option to let the bass pattern play it's full length even when the chord changes (useful too).
A two bar bass riff:
Another classic:
https://www.youtube.com/watch?v=50xx1_CbJTI
Two bar bass riffs
-
- KVRian
- Topic Starter
- 544 posts since 24 Jan, 2004 from Sweden
You do not have the required permissions to view the files attached to this post.
-
- KVRian
- 1111 posts since 3 May, 2005 from Victoria, BC
Hi Stuttaton,
You'll be able to do this in Waveform 8.1.1. I've changed it so when you create a pattern you will be given an option on how to break it up (based on a number of beats). In this case you'd select 8. I've also made it in the chord progression editor, you can now pull the length of each chord up to 16 beats. This version should be released in a week or so.
R
You'll be able to do this in Waveform 8.1.1. I've changed it so when you create a pattern you will be given an option on how to break it up (based on a number of beats). In this case you'd select 8. I've also made it in the chord progression editor, you can now pull the length of each chord up to 16 beats. This version should be released in a week or so.
R
-
- KVRian
- Topic Starter
- 544 posts since 24 Jan, 2004 from Sweden
Wonderful! This will make the bass editor not just a bass editor but a general riff editor.
