Hi,
do have somebody convincing TB-303 / Acid patches for Zebra. I tried but do not nail the sound.
Thanks
Acid with Zebra (TB-303 Sounds)
-
- KVRist
- 40 posts since 15 Nov, 2014
Basic patch setup:
1. Start with the initialize patch in Zebra 2
2. Use OSC1 with the Saw to Pulse preset
3. Add VCF1
a. Change filter type to LP Allaround
b. Set the first Cutoff mod to Env2 @ 30.00
c. Set the Resonance to 85.00
4. Play notes while adjusting VCF1 Cutoff
For the famous distorted sound there are two options:
1. Increase VCF1 Drive for a more "Bubbly" type of distortion
2. Add VCF2 in LP Vintage mode and adjust drive for a more crunchy type of distortion
1. Start with the initialize patch in Zebra 2
2. Use OSC1 with the Saw to Pulse preset
3. Add VCF1
a. Change filter type to LP Allaround
b. Set the first Cutoff mod to Env2 @ 30.00
c. Set the Resonance to 85.00
4. Play notes while adjusting VCF1 Cutoff
For the famous distorted sound there are two options:
1. Increase VCF1 Drive for a more "Bubbly" type of distortion
2. Add VCF2 in LP Vintage mode and adjust drive for a more crunchy type of distortion
-
- KVRAF
- 25441 posts since 3 Feb, 2005 from in the wilds
Cause it is fun to figure out and learn...AnX wrote:Why would you use zebra, and not a dedicated 303 emu?
Cause one wants to also morph the sound in ways that the 303 emu cannot...
There are a couple reasons
