Bitwig

jscro626 · Post by **jscro626** » Fri Jul 21, 2017 8:53 pm

Not sure if this is a Reaktor or Bitwig issue...

When trying to route audio out of my soundcard, Reaktor/Bitwig only give me stereo output to do so, no mono. I have all my soundcards outputs set up properly and have no issues routing mono signals, except in Reaktor. I'm watching tutorials where I see the user has mono channels, what gives?

jscro626 · Post by **jscro626** » Sat Jul 22, 2017 6:35 pm

This is probably way less cryptic with screenshots. When setting up a chain in Reaktor, the tutorial I'm watching shows stereo and mono outputs.

http://imgur.com/a/r3qIH

When I set it up, I only see stereo pairs.

http://imgur.com/a/Lf7tB

don_looney · Post by **don_looney** » Sat Jul 22, 2017 10:28 pm

I will check it tomorrow in my setup. I have Reaktor 6 too. Maybe this is a setting inside reaktor.
Or you have to add missing chains

don_looney · Post by **don_looney** » Sun Jul 23, 2017 5:56 pm

I tried it but for me its the same. Only stereo outputs.
But you can split them in bitwig if you need it. Maybe the picture with mono outs was from an older bitwig or reaktor version.

jscro626 · Post by **jscro626** » Mon Jul 24, 2017 10:09 pm

Appreciate it, I think that may be the issue. I believe I read only stereo chains were supported in the latest version and I'll just work with that limitation in mind here on out.

Bitwig

KVR Audio

Reaktor 6 and Bitwig 2