Just thought of a minor feature request which didn't come up in the searches - would like boolean automation lanes for turning sections on and off. At the moment when I automate, say, turning the bandpass filter on, I have to draw the lines at 0 or 100 rather than having them snap to on or off.

For Version 2 CamelSpace:

Arpeggiator with drawable patterns (would have a button for arp mode, patterns drawable where the trancegate is located -- Gate should ALSO be usable through parallel or serial modes with pre and post-arp modes with gate)

Drawable patterns (again in the trancegate section) for the delay that would also tie in with the shuffle on the gate

Stereo gate mode (dual, independently drawn left and right channels for gate) with single pattern choices (instead of having dual completely independent gating - I want the gate channels dual and independently drawn [stereo] but the patterns to address both).

Larger GUI window (wider not taller)

Smoother frequency range on filter, especially on the high end. It seems to jump in large amounts after 5 or 6khz.. It needs to have a MUCH more higher resolution and smoother range.

Reverb is also very metallic and not incredibly useful (unless you want ringy, metallic reverb) -- an update would be nice on that too.

If you have any questions on this, feel free to PM me. I'd love to discuss these with you.
Last edited by VitaminD on Mon Feb 11, 2013 5:11 pm; edited 4 times in total

Hello,

Recently I purchased CM magazine with freeware (with CM magazine) DiversionFX made by Dmitry Sches. What I like in this plug-in and I'd like see in CamelSpace/CamelPhat:
- Larger view.
- Flexible routing - 2 buses, user could replace FX items in buses. If one bus is enabled without FX items, DiversionFX works like send efect.
- 4 LFO.
- 4 MSEG!
- Modulation matrix.
- For each item (separated fx items, Transgate, MSEG) user could load sub-presets dedicated for this selected item. So it really facilitate creating of new "main" presets.

Best regards,
Janusz

Hi,

I'd like to see 1/4 bars length implemented in CS's trance gate.

---
All the best,
Paul

The Magic EQ Tune goes down to 60hz in CP3 compared to 0Hz on Alchemy. There is also a difference between the top values. It would be great for the range 0 to 120hz to be uniform across both programs.

Importing MIDI with Drag&Drop from the host sequencer&vice versa!

It would be nice and handy!