Gloria is a VST equalizer win32 which comes with a special shape of bells.
To get me, basically consists of two overlapping bells, one of them with the Q wide and the other that tapers while increasing the gain.

Gloria also has a high-pass filter between 20 and 200 Hz with a slope control which can be switched between 6, 8, 12 and 24 dB.
The low-pass filter ranges between 20 KHz and 2 KHz with the same characteristics as the high-pass one.

Low Shelf with a gain of + -12 dB and an action range between 50 Hz and 2 KHz.
High Shelf with a gain of + -12dBs and an action range between 1 kHz and 17 KHz.
The slope of both is fixed.

Both bands, although similar, are slightly different, it depends in Q.
The first acts between 35 Hz and 2 KHz and the second between 200 Hz and 20 KHz, due it has oversampling does not deform the bell at reaching to 20 KHz.

We also have a switch on and off, another to switch between mono and stereo, another one to reverse the polarity and other, finally, to change the saturation mode being A and B.
A mode contains both odd and even harmonics latter being more prominent.
In mode B it has the same amount of even harmonics but only increasing the odds.
In any case, none of both modes have an excessive saturation.
Mode A is -62 THD (total harmonic distortion) and the B -41.

Please download it... then tell me.

Maravillosa interface.

Thanks for the freebie, paisano