i would like to use iCON iCONTROLs in MuLab, but all the buttons sends 90-9F as status byte - tested with MIDI-OX.
which means that pressing this buttons sends a note on/off command.

i have contacted iCON support but the answer was unhelpfully - "You can change the mode via I-Map from Mackie control to user dvined...!".
With iMap iControl i can only change data1 byte but not the status byte.
On Cubase, Logic, Life and Samplitude i-CONTROLs is supported by Mackie Control.

On MuLab i have configured i-CONTROLs now as midi device 16 and so i can use the transport buttons, faders and controllers, but i can't use buttons for mute and solo because status byte for this buttons is 90-9F, because MuLab only expected Controller Commands.

Workaround to change status byte from 90-9F to B0-BF:
edit saved iMap iControl file iControl.icon with text editor and add offset value 32 to each channel -> see table below (comments are not part of iControl.icon!).

modifyed content of iControl.icon (first relevant bytes):

240
29
3
0
26
0
32 - 6x Transport knob channels set to channel 1
32
32
32
32
32
0
1
2
3
4
5
6
7
8
0
1
2
3
4
5
6
7
8
32 - 18x left side Fader buttons set to channel 1..9
32
33
33
34
34
35
35
36
36
37
37
38
38
39
39
40
40
:

load modifyed file into iMap iControl and send it to your i-Controls.

Now, the only problem is that i-Controls sends for each 2 buttons on the left fader side 2 CCs with value 0 and 127.

if it's possible to add in MIDI controller map for Source an addditional value, how realised for shortcuts we could use this buttons for mute and solo.