New update again, as promised. This time it is a single feature, but boy, has this been a long requested one:
Switchable Mono/Stereo outputs!
Yes, in the TX16Wx professional you can now freely turn the mono outputs into stereo pairs, thus enabling 4-8 stereo outputs. Trust me, this was trickier than it sounds to implement well.
Mono pairs can be turned into stereo in the settings page, and the current setup will be saved with the bank data. Please note the setting that determines which bank data files will load output configuration though; by default, only DAW bank data (your project file) will load output configuration, not a bank file read from disk. This is because while TX16Wx internally will happily switch its operating mode, the containing host will not, and you must rebuild your output routing when you change the output configuration.
Version 2.1.0 b6 (2013-02-17)
- Mono outputs can now be switched to stereo busses in pro version
Download as always from http://www.tx16wx.com/
Next up in TX16Wx land will be a special gift to you all, that I hope will forever end the debate on which is the greatest software sampler of all times (hint: the correct answer begins with a T and is hard to pronounce unless you are Swedish). Also, I will add to the effects palette and fix some of the old work flow issues I know of.