Latest News: Bitwig Updates Bitwig Studio to 5.2
Reaktor 6 and Bitwig 2
-
- KVRer
- Topic Starter
- 9 posts since 7 Mar, 2017
Not sure if this is a Reaktor or Bitwig issue...
When trying to route audio out of my soundcard, Reaktor/Bitwig only give me stereo output to do so, no mono. I have all my soundcards outputs set up properly and have no issues routing mono signals, except in Reaktor. I'm watching tutorials where I see the user has mono channels, what gives?
When trying to route audio out of my soundcard, Reaktor/Bitwig only give me stereo output to do so, no mono. I have all my soundcards outputs set up properly and have no issues routing mono signals, except in Reaktor. I'm watching tutorials where I see the user has mono channels, what gives?
-
- KVRer
- Topic Starter
- 9 posts since 7 Mar, 2017
This is probably way less cryptic with screenshots. When setting up a chain in Reaktor, the tutorial I'm watching shows stereo and mono outputs.
http://imgur.com/a/r3qIH
When I set it up, I only see stereo pairs.
http://imgur.com/a/Lf7tB
http://imgur.com/a/r3qIH
When I set it up, I only see stereo pairs.
http://imgur.com/a/Lf7tB
-
- KVRist
- 351 posts since 18 Oct, 2015 from Germany
I will check it tomorrow in my setup. I have Reaktor 6 too. Maybe this is a setting inside reaktor.
Or you have to add missing chains
Or you have to add missing chains
RME Babyface Pro / Bitwig / Adam A7X / Elektron AR MKII / Novation Peak / Akai Force / Eurorack
-
- KVRist
- 351 posts since 18 Oct, 2015 from Germany
I tried it but for me its the same. Only stereo outputs.
But you can split them in bitwig if you need it. Maybe the picture with mono outs was from an older bitwig or reaktor version.
But you can split them in bitwig if you need it. Maybe the picture with mono outs was from an older bitwig or reaktor version.
RME Babyface Pro / Bitwig / Adam A7X / Elektron AR MKII / Novation Peak / Akai Force / Eurorack
-
- KVRer
- Topic Starter
- 9 posts since 7 Mar, 2017
Appreciate it, I think that may be the issue. I believe I read only stereo chains were supported in the latest version and I'll just work with that limitation in mind here on out.