Volume
-
- KVRer
- Topic Starter
- 2 posts since 29 Apr, 2010
Hey guys I'm new to sonic birth, was wondering if there was a way within sonic birth to control the output volume?
I keep accidentally blowing my ears off while experimenting. And I sort of look like this
Thankyou
I keep accidentally blowing my ears off while experimenting. And I sort of look like this
Thankyou
-
- KVRer
- Topic Starter
- 2 posts since 29 Apr, 2010
Worked it out for myself
In the process blowing my ears off again.
In the process blowing my ears off again.
-
- KVRer
- 3 posts since 11 May, 2010
Im having the same trouble myself, how did you solve it?
-
- KVRer
- 26 posts since 18 Nov, 2008 from Stuttgart Germany
Hi
You can set a multiplication at last Object.
If you put on one input your signal and the other a slider (0-1) you can set the output volume.
You can set the slider to decibels and between -60 to 0.
Then setup a db to linear converter between the slider and the multiplication and you there you go with exactly db measurements.
You can set a multiplication at last Object.
If you put on one input your signal and the other a slider (0-1) you can set the output volume.
You can set the slider to decibels and between -60 to 0.
Then setup a db to linear converter between the slider and the multiplication and you there you go with exactly db measurements.
Sound Like Dynamite!
Visit me @:
http://jester-dyne-productions.com
Facebook
http://www.myspace.com/jesterdyne
Visit me @:
http://jester-dyne-productions.com
http://www.myspace.com/jesterdyne