Pan Oscillator Glitch? |SOLVED|

Official support for:
User avatar
4 posts since 1 Feb, 2018

Post Sat Feb 03, 2018 3:19 am

Hello again

I'm trying to make a pan oscillator that jumps the sound from left to right. I'm using a square wave generator (at a low frequency) where +1 is right and -1 is left. However there is a popping noise as it leaps between the two sides. This doesn't happen when I use a sine wave, here the transition is smooth, so it must be caused by the immediate leap from +1 to -1. (It also happens when I use a saw wave).

Is there a way around this? I've had my head in it for about 12 hours so I'm sorry if this doesn't make sense.

EDIT: I found the answer. Add a 'Change Slower' element after the square/saw generator. Now I can't figure out how to delete this post!

Return to “SonicBirth”