Hello,
Newbie here. I just started with Cantabile Performer. I am trying to get my controller keyboard to play both a VST and an external hardware synth at the same time using the routing table. Here is a sample scenario of what I am trying to do:
Use controller Axiom 25 to play Arturia CS-80 VST and a Roland D-550 hardware sound module at the same time (layered sound). I seem to be able to play one or the other according to whichever routing is listed on top, but not both at the same time.
For my midi/audio interface I am using a Roland Quad-Capture.
Thanks!
help routing to external sound module
-
- KVRer
- Topic Starter
- 16 posts since 17 Jun, 2015
-
- KVRist
- 196 posts since 11 Sep, 2004 from Germany
Hi,
most probably you forget to activate the MIDI through button in the first midi routing (little MIDI-Plug icon with down arrow). If this is desected, MIDI data isn`t transferred to the next routing so only the firts routing is active.
regards, humphrey
most probably you forget to activate the MIDI through button in the first midi routing (little MIDI-Plug icon with down arrow). If this is desected, MIDI data isn`t transferred to the next routing so only the firts routing is active.
regards, humphrey
hosts: c8.5, cantabile3.0, forte4.0, live 9, trakor
hardware: i7 4770k, i7 4702qm, all audio converters RME, KH120A
vsts / vstis: u-he, voxengo, fabfilter, izotope, lexicon, waves, spectrasonics, ni, steinberg, gsi, uvi, xfer & others
hardware: i7 4770k, i7 4702qm, all audio converters RME, KH120A
vsts / vstis: u-he, voxengo, fabfilter, izotope, lexicon, waves, spectrasonics, ni, steinberg, gsi, uvi, xfer & others
-
- KVRer
- Topic Starter
- 16 posts since 17 Jun, 2015
Thank you! Clicking the midi through icon did the trick.
