Shift Dry/Wet?

[pinki]

I can't figure out how to make Shift do dry/wet. It has a Dry knob, an Input and an Output but I cannot use them to alter the ratio of dry to wet?

[colin@loomer]

Use the Dry Volume (in the Global Panel) to control the amount of Dry source signal, and then set the amount of wet signal per voice with the voice Volume knob. This gives more flexibility than a single wet/dry control, although thinking about it, I can perhaps so the benefit of adding one in a future iteration.

[pinki]

Thanks Colin..it was the 'per voice' bit that was catching me out I think.