Loomer

gentleclockdivider · Post by **gentleclockdivider** » Fri Jul 05, 2019 10:55 am

I am recording the midi output of architect into my daw , but the midi repeat module always outputs sustained notes .

colin@loomer · Post by **colin@loomer** » Fri Jul 05, 2019 1:04 pm

I'll take a look. Could you upload or PM me an example patch, please? Thanks.

gentleclockdivider · Post by **gentleclockdivider** » Fri Jul 05, 2019 4:35 pm

there really isn't that much to upload
I just route a seqencer trough the midi repeat and record the (midi ) output
Sustained notes ( an no note-offs ) ar alle over the place

colin@loomer · Post by **colin@loomer** » Sat Jul 06, 2019 8:51 am

Ok, thanks, I'll see if I can reproduce the issue myself.

colin@loomer · Post by **colin@loomer** » Wed Jul 10, 2019 2:22 pm

What were you trying to do with this module? The [MIDI repeat] module (and the equivalent [data repeat] module) will keep repeating the last MIDI or data event that it receives, at the specified duration. Therefore if you send it a note-on, it will keep repeating it; same with note-off. If you want a MIDI echo, you should use the [MIDI Delay] module instead.

gentleclockdivider · Post by **gentleclockdivider** » Wed Jul 10, 2019 3:23 pm

For firing off rapid midi notes .

colin@loomer · Post by **colin@loomer** » Wed Jul 10, 2019 3:39 pm

I'd use a [pack note] module, as that automatically generates both note-ons and note-offs.

Loomer

KVR Audio

Midi repeat module