String Bend for Bouzouki

Official support for: impactsoundworks.com
KVRist
46 posts since 3 May, 2020

Post Mon May 03, 2021 4:06 pm

Is there a string bend feature for the Bouzouki that I can't find? Currently I have to mimic it thru careful use of slides but this takes a lot of time. A "real" string bend would be a nice feature to have. It is mainly for small/short ornamentations so up to a 1/2 step would be enough, but usually I would use less than 1/2 step.

Return to “Impact Soundworks”