Equalize 2 bug? My fault?

Official support for: acondigital.com
KVRian
580 posts since 4 Jan, 2007

Post Thu Nov 25, 2021 11:11 am

Hello.

Using Win10, VST3, Reaper 6.34.

1.) I select a highpass and set it to the highest frequency. Blocks all signal, as expected I get no sound.
2.) I set the channel mode to L or R.
3.) Now I hear both channels.

I would expect to only hear one channel.

Now I hard pan a sound with no high frequency to the left and apply the same highpass. If i select the mid channel the sound gets completely muted. If I select the side channel there is no gain change.

A hardpaned sound when converted to M/S should have the same energy on both channels (M and S) I think.

What am I doing wrong?

KVRian

Topic Starter

580 posts since 4 Jan, 2007

Post Tue Nov 30, 2021 10:21 am

Can anyone confirm?

KVRer
25 posts since 6 Dec, 2004

Post Tue Nov 30, 2021 1:18 pm

This is the normal behavior since when you select L or R the filter is applied only to one channel not both has in the stereo position! Right ? ;)

Return to “Acon Digital”