So I'm experiencing two problems with Equalize 2, I created two videos to show them and uploaded them to google Drive. Daw is Reaper.
In the example Equalize2 was put in a 5.1 channel track with crickets sound; there is no other automation going on.
1) Automation of a low pass filter. If you see in the video (number 1) if you automate the freq and then you jump back where is no automation, the GUI refreshes, but the sound doesn't. As soon as it encounters an envelope point, it refreshes the filter. As previously suggested I chose "Minimum Phase".
2) Given that Mixed phase with automations is to avoid (because it takes too much CPU and introduces some problems) I tried to choose Linear Phase. Choosing "linear phase" causes +700dB peak in the track (video Number 2).
https://drive.google.com/open?id=1DJGTY ... xm8XsvWupT (https://drive.google.com/open?id=1DJGTY0swy9gOwBRf3fVzA0xm8XsvWupT)
https://drive.google.com/open?id=1i0gO7 ... Y_V-uhUxYU (https://drive.google.com/open?id=1i0gO7XXWqcXw4cDYNQcMXQY_V-uhUxYU)
Thank you in advance for your support.