DeVerberate 3: is it possible to output only the detected ERs through the "Difference" feature?

Official support for: acondigital.com
User avatar
KVRist
429 posts since 18 Aug, 2006 from Italy

Post Sat Oct 23, 2021 2:24 am

The "Difference" feature of DeVerberate 3 is interesting, as it allows to listen to the removed "reverberated" part of the signal. I was wondering if there is any setting I could apply to listen only to the detected Early Reflections. Do you think that this is possible? Thank you.
www.GKweb.it
Mac, OS X 10.14, Logic Pro X

User avatar
KVRian
1237 posts since 1 Jan, 2005 from Norway

Post Wed Oct 27, 2021 1:53 am

XComposer wrote:
Sat Oct 23, 2021 2:24 am
The "Difference" feature of DeVerberate 3 is interesting, as it allows to listen to the removed "reverberated" part of the signal. I was wondering if there is any setting I could apply to listen only to the detected Early Reflections. Do you think that this is possible? Thank you.
Yes, the difference does that. If you want to listen to the effect of the early reflections filter alone, you will need to enable the reverb source and set both dry and reverb levels to 0 dB, and then activate the difference mode.

Best,
Stian

User avatar
KVRist

Topic Starter

429 posts since 18 Aug, 2006 from Italy

Post Wed Oct 27, 2021 12:09 pm

Interesting. Thank you, takk så mye (studying Norwegian, here).
www.GKweb.it
Mac, OS X 10.14, Logic Pro X

User avatar
KVRian
1237 posts since 1 Jan, 2005 from Norway

Post Tue Nov 09, 2021 7:37 am

XComposer wrote:
Wed Oct 27, 2021 12:09 pm
Interesting. Thank you, takk så mye (studying Norwegian, here).
Veldig hyggelig å høre at du lærer deg norsk! :clap:

Best,
Stian

Return to “Acon Digital”