Waveform midi clock

Discussion about: tracktion.com
droolmaster0
KVRian
998 posts since 2 Aug, 2004

Post Sun Oct 22, 2017 1:13 pm

It's easy to send midi clock out to any of the midi devices enabled in Waveform. However, I do not see a rather important option (I think that most DAWs have this) which is to always send a start message whenever the edit is stopped then started. I am finding that I need to rewind to the beginning to do this, which is rather a pain.

Am I missing where this can be set up? it took me all of a few seconds to find and implement this in Cubase....

droolmaster0
KVRian
998 posts since 2 Aug, 2004

Re: Waveform midi clock

Post Sat Nov 04, 2017 7:15 am

Well, this is frustrating. 2 messages to Tracktion support, and simply no response at all.

jabe
KVRAF
1889 posts since 9 Oct, 2008 from UK

Re: Waveform midi clock

Post Sat Nov 04, 2017 11:59 am

There is a way to add control codes (and, apparently, sysex codes) in the MIDI editor. It might be possible to add the one you want. To save you rewinding and losing your place, perhaps you could set it up on its own in an Edit and just play/send it from there.
[W10-64, T5/6/7/W8/9/10, 32&64, Spike],[W7-32, T5/6/7/W8, Gina16] everything underused.

koreski.phil
KVRer
16 posts since 15 Mar, 2016

Re: Waveform midi clock

Post Wed Jul 31, 2019 3:57 pm

I know this thread is old but in your edit go to "timecode" in the lower left of the screen. There you can change settings for receiving or sending MMC (MIDI Machine Control) messages to/from devices.

Return to “Tracktion”