Pattern Sequencer

Official support for: kirnuarp.com
KVRer
4 posts since 7 Jul, 2015

Post Sat Oct 17, 2015 6:13 pm

The Pattern Sequencer is not working for me. The pattern columns iterate in the Pattern Sequencer section when I enable the sequencer but the Patterns do not change in the Patterns section. It just stays on Pattern 1 unless I manually change it.

I am using Cubase 8 and Windows 10. Cream 1.2.0 registered version.

KVRer

Topic Starter

4 posts since 7 Jul, 2015

Post Sun Oct 18, 2015 8:16 am

Solution: PUSH THE PANIC BUTTON.
I tried the Pattern Sequencer in Reaper. Same result as Cubase. Would not step through the patterns. Then it dawned on me to hit the Panic button in the upper right corner. Fixed it. I have a feeling that button is going to be very useful. Should be capitalized in red on every page of the manual. PUSH THE PANIC BUTTON. I kept changing the sequencer parameters in real time until it eventually stopped stepping. The Panic button fixed it every time.

Return to “Kirnu”