Introduction to Modular Synthesis with SoloRack

Modular Synth design and releases (Reaktor, SynthEdit, Tassman, etc.)
rofilm
KVRist
106 posts since 30 Sep, 2013 from Czech Republic

Post Fri Nov 10, 2017 11:32 am

Introduction to modular synthesis: SoloRack Tutorial 3: The Oscillators Part 1 is online now:
https://youtu.be/Vaa3Jzt56kc

Please see the timeline below for further details.

Timeline and Content
00:00 Introduction
01:18 The SA 310 VCO
02:00 Pitch Range
02:24 1 Volt/Octave
03:19 Trigger, CV and Gate
04:38 “... and it´s this jump to the left ...”
09:07 The Waves
11:22 Analogue Exponential Frequency Modulation
18:35 Pulse Width Modulation (PWM)
20:16 Duty Cycles
22:28 Phase Shifts
27:20 PWM and Oversampling
28:55 Hardsync
40:05 “Bend”
42:28 Half-Wave Rectifier (RA)
45:25 About Phase Shifts Again
49:47 PATCHING! PATCHING! PATCHING!
52:08 Some Words at the End
53:45 The End
Image
Enjoy your Life!
Rolf

rofilm
KVRist
106 posts since 30 Sep, 2013 from Czech Republic

Re: Introduction to Modular Synthesis with SoloRack

Post Sun Nov 12, 2017 1:13 am

Hello Everybody! There were some technical problems with my video cut software, which led to noise at some parts of the video. The problems are solved by now, but the video was online before solving them. So, the noisy parts (from time to time) are not caused by SoloRack, but by my video cut software(s) - indeed I had to use two different ones for some reasons. Have a good time! Rolf

Return to “Modular Synthesis”