2.0 Authorization
-
- KVRer
- Topic Starter
- 4 posts since 24 Feb, 2005
I know this is a shot in the dark, but had to replace a motherboard on a receptor 2. All works except it is asking for the authorization to go into rack mode again. The authorization servers are obviously out of biz as well. Anyone know of a way around this?
-
- KVRist
- 144 posts since 20 Feb, 2013
Hi
Same thing happened to me just beffore muse went Bang.
i had to get a new autherization code from support.
The old one was linked in some way to the old board proberbly a mac adress .Support gave me a new code and it worked.I was lucky i think it was a week before they closed.
Good luck Andy
Same thing happened to me just beffore muse went Bang.
i had to get a new autherization code from support.
The old one was linked in some way to the old board proberbly a mac adress .Support gave me a new code and it worked.I was lucky i think it was a week before they closed.
Good luck Andy
-
- KVRer
- Topic Starter
- 4 posts since 24 Feb, 2005
Thanks for this, but I have the code. I get an internet error code that cannot connect to the auth server which I am guessing is no longer. Wish they would have put an unlocked update up for everyone who bought units before they went under as a good faith. I bought 3 new units right before they went under.
"This unit could not be activated. Please check your internet connection and insure that the key is entered exactly as its shown..."
"This unit could not be activated. Please check your internet connection and insure that the key is entered exactly as its shown..."
