Receptor starts in a "blank patch", not in the last selected patch

Discussion and Support for Receptor and MuseBox, the Hardware Plug-in players by Muse Research.
1 posts since 27 Jul, 2017

Post Sun Apr 01, 2018 12:57 am


Since yesterday I have the following problem. My Receptor VIP has started up for about three seconds and then instantly shut down, reboots, shut down, again and again... I was not possible to start it up.

After several (many) trys to start it there came a message "Can not start up - No Communication Link".

After that I changed the RAM, now he starts reliable, but he starts up not in the last patch I have selected, but in a "blank patch". Booting from the backup drive has the same result. He starts, but always in a "blank patch".

After that I also changed the battery on the Main Board, that did not help.

Is there probably something damaged? What is the problem? The RAM, the Main Board, any settings in Receptor, the BIOS, any flash memory?

Thank you for your help in advance!!!


207 posts since 6 May, 2014 from New Mexico

Re: Receptor starts in a "blank patch", not in the last selected patch

Post Mon Apr 02, 2018 3:51 pm

Any error codes other that that message?
Fish Out Of Water
Entune Productions

Return to “Muse Research and Development”