Live 11 : Pitch Bend Bug ?
-
- KVRian
- Topic Starter
- 839 posts since 25 Jan, 2014
I noticed that when I automate the pitch bend wheel in Serum even if I bring back the automation point to 0.50 in Ableton it doesn't necessarily bring the pitch bend wheel to 0.00 but rather like 0.11.
And if I slightly move up and down the automation point even if it stay to 0.50, the value of the pitch bend change like 0,12, 0.11, 0.08...
I knew that visually, 2 dot at like 0.50 were not necessarily at the same height but never notice it was really affecting the parameter. But now I see that the pitch isn't correct.
As if the automation dot values were not precise enough.
Has it always been like this or it's new to Live 11 ?
And if I slightly move up and down the automation point even if it stay to 0.50, the value of the pitch bend change like 0,12, 0.11, 0.08...
I knew that visually, 2 dot at like 0.50 were not necessarily at the same height but never notice it was really affecting the parameter. But now I see that the pitch isn't correct.
As if the automation dot values were not precise enough.
Has it always been like this or it's new to Live 11 ?
-
- KVRian
- 617 posts since 4 Feb, 2017
This has to do with the fact the pitch bend range in Live goes from 0 to 1. In Serum it goes from -1 to 1 (or whatever setting you choose). So the neutral position 0 in Serum has a value of 0.5 in Live.
-
- KVRian
- Topic Starter
- 839 posts since 25 Jan, 2014
Here is a gif to show what I mean. On the gif I drag up and down the automation point while pressing shift to get more precision. As you can see the value 0.50 stay the same even though the red line is moving AND the value of the pitch bend is changing in the bottom serum square. And it's the same with filter cutoff parameter ...and the same with Sylenth1.
But with stock Live's plugin it's ok. As soon as you move the red line the value changes. I just verify and it's the same with Live 10.
But with stock Live's plugin it's ok. As soon as you move the red line the value changes. I just verify and it's the same with Live 10.
- Banned
- 11467 posts since 4 Jan, 2017 from Warsaw, Poland
Right-click on that automation point and there's option up top to enter exact breakpoint value (of 0.5). Probably Live is only displaying 2 decimal points, but there's lots more after it?
See if that helps.
-
- KVRian
- Topic Starter
- 839 posts since 25 Jan, 2014
Thanx I didn't knew about that "edit value".
Yes it looks like the value displayed are not precise enough since it doesn't follow the movement of the red line... it would take something like 0.5000