Rack in MUX-GUI

Official support for: mutools.com
nenneb
KVRist
117 posts since 8 Dec, 2015

Post Sun Nov 12, 2017 5:08 am

I just try to build a MUX for split-keyboard-playing. No problem: Two racks in the MUX and a "note key/vel Filter" before each of them to set the splitpoint and an amplifier after them. Now I can drag the amp's gains to the GUI, ok.
I also can drag the racks to the GUI. But then I only get a "button" that opens the rack. And to open an entry I need an additional click not to mention the (unwanted) floating rack.
Is there a possibility to put an "opened" rack onto the GUI?

mutools
KVRAF
9544 posts since 24 Jun, 2008 from Europe

Re: Rack in MUX-GUI

Post Sun Nov 12, 2017 5:46 am


nenneb
KVRist
117 posts since 8 Dec, 2015

Re: Rack in MUX-GUI

Post Sun Nov 12, 2017 11:10 pm

Great! :-)
Thank you! I should have read (and understood) the manual ....

akeia
KVRist
121 posts since 14 Nov, 2016 from Berliner Umland

Re: Rack in MUX-GUI

Post Mon Nov 13, 2017 2:27 am

nenneb wrote:I should have read (and understood) the manual ....
Well, this question pops up again and again. In my opinion this is an issue of insufficient user interface design.

I think there should be some visual indication of non-obvious drag sources when the front panel is in edit mode. When the user sees inner icons within an element in edit mode it will be obvious that there is a "separate thing".

mutools
KVRAF
9544 posts since 24 Jun, 2008 from Europe

Re: Rack in MUX-GUI

Post Mon Nov 13, 2017 2:57 am

I'll check whether that aspect can be improved in a future version.

Return to “MUTOOLS”