MUX triggering Envelopes with Note Off?
-
dreammachine_nl dreammachine_nl https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=30537
- KVRist
- 59 posts since 23 Jun, 2004
The most flexible (as in most editable) solution is to use a Multi-Point Envelope.
See picture below:
-Insert a couple of points (three or more).
-Set the first one to 'loop start' and the second one to 'loop end'.
-Set the 'On Note Off' property to 'Stop Looping'.
Finally, move both loop points to the very left of the envelope graph (see picture below). The visible part of the graph will now only be started on a 'Note Off' event.
See picture below:
-Insert a couple of points (three or more).
-Set the first one to 'loop start' and the second one to 'loop end'.
-Set the 'On Note Off' property to 'Stop Looping'.
Finally, move both loop points to the very left of the envelope graph (see picture below). The visible part of the graph will now only be started on a 'Note Off' event.
You do not have the required permissions to view the files attached to this post.
- KVRAF
- 12689 posts since 24 Jun, 2008 from Europe
Thx dreammachine_nl for sharing your creative solution.
In the next update there also will be a new module which can create a note-on upon a note-off. So then you can create sounds / effects where a new sound / effect is started upon releasing a key.
In the next update there also will be a new module which can create a note-on upon a note-off. So then you can create sounds / effects where a new sound / effect is started upon releasing a key.