After working normally for multiple sessions, the instrument suddenly stops producing sound after opening save - no changing any settings in the instrument or DAW. The instrument is receiving midi message, just doesn't seem to put it through. Other presets work as normal.
This has happened on multiple instances of Sylenth and different presets. I create a new channel, it works for a while then does the same thing. The channel strip is receiving something back from Sylenth, but it is inaudible.
Running Studio One on Windows 10.
Instrument stops producing sound in Studio One
-
- KVRian
- 1302 posts since 25 Sep, 2006
The problem is most likely caused by something in your setup sending Midi data to Sylenth1, that Sylenth1 responds to. This can cause a parameter to change, such as one of the Volume or Mix knobs.
To locate the source of the midi input, try changing the midi input in your DAW, or disconnect any midi hardware.
You can also clear the default Midi learned parameters by overwriting the MidiLearn.dat file in the Config folder in the Sylenth1 data folder (click MENU -> Open Data Folder to get there quickly), by unzipping the file below to that location (make sure to quit Sylenth1 before doing so):
https://www.lennardigital.com/files/tem ... nEmpty.zip
If you're using RME ARC, make sure to either turn off the midi input from that device or to change the communication data to SysEx in the device's firmware.
To locate the source of the midi input, try changing the midi input in your DAW, or disconnect any midi hardware.
You can also clear the default Midi learned parameters by overwriting the MidiLearn.dat file in the Config folder in the Sylenth1 data folder (click MENU -> Open Data Folder to get there quickly), by unzipping the file below to that location (make sure to quit Sylenth1 before doing so):
https://www.lennardigital.com/files/tem ... nEmpty.zip
If you're using RME ARC, make sure to either turn off the midi input from that device or to change the communication data to SysEx in the device's firmware.
