XT Software

GooGooMuck · Post by **GooGooMuck** » Sun Nov 20, 2005 6:49 am

When I unlink the outputs on the sequencer, everything goes quiet. I have a mono input to the seq. and can hear it fine until unlinking. I have tried connecting both mono outputs, setting pans in the seq. mixer, checking outputs for the audio track etc. What am I doing wrong?

DarkStar · Post by **DarkStar** » Sun Nov 20, 2005 7:54 am

Nothing I don't think, confirmed here.

plastique · Post by **plastique** » Thu Nov 24, 2005 3:21 pm

I didn't notice this post and made an extra BR - topic about this .
Also , if you replace the sequencer (like as shown in the image above) with an eXT VSTi the same issue appears .

plastique · Post by **plastique** » Fri Nov 25, 2005 5:01 pm

Machinate · Post by **Machinate** » Wed Jan 04, 2006 11:05 am

And another friendly bump from me - I tore a bit of hair out over this one today. Alas, I'm an XT newb, so I may have been the culprit.

soma · Post by **soma** » Thu Jan 05, 2006 1:39 am

Critical bug IMHO

Been mentioned a bunch
http://www.kvraudio.com/forum/viewtopic.php?

http://www.kvraudio.com/forum/viewtopic ... 26#1536826

XT Software

KVR Audio

No sound after unlinking outputs