Does ChineePiPa support pitch bend?

Official support for: chineekong.com & kongaudio.com
berrisbob
KVRer
2 posts since 16 Dec, 2012

Post Sat Dec 15, 2012 10:55 pm

I want to do some pitch bends with the pipa, but it doesn't seem to support it. Is it possible to do this (aside from the glide feature)? If so, please tell me how I can accomplish it. Thanks.

sosayweall
KVRian
801 posts since 25 Feb, 2005

Post Sun Dec 16, 2012 3:40 am

Hi berrisbob,

QIN RV works fine with standard MIDI pitchbend by default, and it should be very obvious once you start bending a note. What is your host? *If you are using Fruity, please check this thread (on the 2nd page) for some explanations:

http://www.kvraudio.com/forum/viewtopic.php?p=5033378

berrisbob
KVRer
2 posts since 16 Dec, 2012

Post Sun Dec 16, 2012 9:04 pm

I was using Sonar X1. I was finally able to get it to work by explicitly selecting channel 1 for the envelope's controller (even though it was already channel 1 by default).

Thanks for the quick reply.

sosayweall
KVRian
801 posts since 25 Feb, 2005

Post Mon Dec 17, 2012 4:31 am

Hi berrisbob,

I can't reproduce the issue here in X1. Make sure you are using the new QIN RV Pipa if haven't done so yet...

Return to “Kong Audio”