Green Oak Crystal 2.5.6 UI bug
-
- KVRist
- Topic Starter
- 40 posts since 10 Oct, 2012 from Ukraine
Hi there!
I was wondering if anyone has the same (small but annoying) bug as I do in the latest version of Crystal.
Basically, if you change a waveform, say from SawSquare to Sine, it changes controls on the pane appropriately, but leaves the old name of the waveform in the drop down, which is confusing. To fix that, you need to switch to another tab and back.
I have same behavior on 2 computers both in Reaper and Bidule.
Any suggestions how to fix this?
P.S. I may be blind, but I can't find older versions on Internet to check..
I was wondering if anyone has the same (small but annoying) bug as I do in the latest version of Crystal.
Basically, if you change a waveform, say from SawSquare to Sine, it changes controls on the pane appropriately, but leaves the old name of the waveform in the drop down, which is confusing. To fix that, you need to switch to another tab and back.
I have same behavior on 2 computers both in Reaper and Bidule.
Any suggestions how to fix this?
P.S. I may be blind, but I can't find older versions on Internet to check..
- Banned
- 7624 posts since 13 Nov, 2015 from Norway
I have the same 'problem'. Its not a big deal actually
EnergyXT3 - LMMS - FL Studio | Roland SH201 - Waldorf Rocket | SoundCloud - Bandcamp
- Banned
- 7624 posts since 13 Nov, 2015 from Norway
EnergyXT3 - LMMS - FL Studio | Roland SH201 - Waldorf Rocket | SoundCloud - Bandcamp
-
- KVRist
- 168 posts since 9 Mar, 2003
I would love to see a reescalable GUI for Crystal.