Tal uno LX V2 with Roli seaboard / mpe
-
- KVRist
- Topic Starter
- 63 posts since 15 Nov, 2004 from London
Anyone got any tips as to how to set this up?
Not sure how to set up the roli dashboard.....
16 channels?
MPE mode or multichannel?
Not sure how to set up the roli dashboard.....
16 channels?
MPE mode or multichannel?
-
Echoes in the Attic Echoes in the Attic https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=180417
- KVRAF
- 11054 posts since 12 May, 2008
Turn on MPE and then there's a little section with MPE mods.
-
- KVRist
- Topic Starter
- 63 posts since 15 Nov, 2004 from London
Are you talking about in the Roli Dashboard?Echoes in the Attic wrote: ↑Thu Aug 13, 2020 1:13 am Turn on MPE and then there's a little section with MPE mods.
Or in TAL uno?
-
Echoes in the Attic Echoes in the Attic https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=180417
- KVRAF
- 11054 posts since 12 May, 2008
tal uno. MPE button to turn it on and then in the control section, you ca assign some basic expresssion - filter for y-axis and volume for pressure. Note that it interprets y-axis as absolute so you might want to set your seaboard to send cc74 value of zero on initial strike (as opposed to 64). Works better with this type of instrument. or else initial strike will be modulated positively by half the range immediately. And yes set seaboard to mpe mode.mozart999uk wrote: ↑Thu Aug 13, 2020 9:57 amAre you talking about in the Roli Dashboard?Echoes in the Attic wrote: ↑Thu Aug 13, 2020 1:13 am Turn on MPE and then there's a little section with MPE mods.
Or in TAL uno?
-
- KVRist
- Topic Starter
- 63 posts since 15 Nov, 2004 from London
Thanks. Appreciate the detail. I'll give that a try
-
- KVRist
- Topic Starter
- 63 posts since 15 Nov, 2004 from London
Just been mucking about with this....I'm getting some odd results.
I set the ROLI to multichannel mode, otherwise I couldn't change cc74 to relative.
However on pad sounds the filter is going haywire- I guess cos there's only one filter for the whole synth rather than a filter per note????
I set the ROLI to multichannel mode, otherwise I couldn't change cc74 to relative.
However on pad sounds the filter is going haywire- I guess cos there's only one filter for the whole synth rather than a filter per note????