“Wiggle Room” features a brass arrangement for the main themes along with piano, upright bass, and a Chapman Stick solo in the outro.
https://soundcloud.com/jeremycubert/wiggle-room
“Wiggle Room” (Jazz Fusion)
-
- KVRian
- 689 posts since 10 Apr, 2015 from Gaithersburg, Maryland USA
-
ChameleonMusic ChameleonMusic https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=430348
- KVRAF
- 1923 posts since 23 Nov, 2018 from Birmingham, UK
Massive, nostalgic memory for me...I played jazz trumpet around the local circuit here in Birmingham UK for a number of years! (Long time ago, now)
Loved the main blues riff - slinks and slides along effortlessly...i'm sitting in my studio and had to start jamming along!
For me, one slight issue was the brass arrangement - didn't quite gel with the overall groove maybe?
Loved the main blues riff - slinks and slides along effortlessly...i'm sitting in my studio and had to start jamming along!
For me, one slight issue was the brass arrangement - didn't quite gel with the overall groove maybe?
Mark Taylor, Chameleon Music - Professional composition and sound design for all media since 1994.
https://www.chameleonmusic.co.uk/
https://www.chameleonmusic.co.uk/
-
Paladin on a Horse Paladin on a Horse https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=478325
- Banned
- 83 posts since 7 Nov, 2020
Not much jazz on this forum and I do like a bit of jazz.
A good bluesy listen but I do agree with the other reply - at times the brass all seems out of step a tad with the other bits.
Good solo at the end - had to look up what a Chapman Stick was.
A good bluesy listen but I do agree with the other reply - at times the brass all seems out of step a tad with the other bits.
Good solo at the end - had to look up what a Chapman Stick was.
Just an old bloke who likes listening to a wide range of music. I also fart quite a lot!
-
- KVRian
- Topic Starter
- 689 posts since 10 Apr, 2015 from Gaithersburg, Maryland USA
Thanks for the listen and the kind words. I appreciate the feedback and will go back and see if I can tighten up the brass section.